PS4 14.00 Jailbreak & DNS

Primary DNS

45.56.67.85

Secondary DNS

62.210.38.117

1. Open the network wizardGo to Settings > Network > Set Up Internet Connection. Choose Use Wi-Fi or Use a LAN Cable, then Custom.
2. Keep your normal IP settingsUse your existing IP and DHCP configuration. For a typical home network these are Automatic and Do Not Specify.
3. Set DNS to ManualPrimary DNS: 45.56.67.85. Secondary DNS: 62.210.38.117.
4. Finish setupKeep the normal MTU and proxy settings; a typical network uses Automatic and Do Not Use. Save and test the connection. You can restore DNS to Automatic later.

• PlayStation network setup reference

1. Check your firmware and equipmentRead Settings > System > System Information. Confirm the video applies to that exact firmware. Prepare a computer, Blu-ray writer and blank supported BD-R/BD-RE media.
2. Get the supplied HEN ISODownload GOLDHEN14.iso Supplied HEN ISO
   Download the ISO using the links here. If the supplied file is an archive, extract it first. Check the video’s current notes and any published checksum before using the ISO.
3. Burn the image to Blu-rayImgBurn downloads
   In ImgBurn choose Write image file to disc, select the ISO and the Blu-ray writer, and burn to the blank disc. Enable verification and let it complete. Copying the ISO as a normal data file does not create the same disc.
4. Start the disc on PS414.00 disc workflow reference
   Insert the finished disc and open its disc/Blu-ray tile. The documented 14.00 disc waits for one Cross (X) press after validation. Follow the instructions shown by the actual image you burned.
5. Confirm HEN successCheck that the HEN features actually work before installing homebrew. After a failure, shut down completely and cold-boot before another attempt; do not repeatedly trigger it in the same session.

PS4 browser address:
https://aminegold0.github.io/silverps4hen/

1. Open the host on the PS4Use the console Internet Browser after configuring the connection. Read the host’s displayed firmware and payload options.
2. Match the payloadUse only a HEN build whose release notes list your firmware and entry point. GoldHEN is linked as a separate project, not as verified 14.00 support.
3. Wait for the resultConfirm success before using Package Installer or other homebrew services. If it fails, follow the host’s recovery notes instead of assuming the console is enabled.