PS Vita Jailbreak Guide · HENlo

Find the installed firmware in Settings > System > System Information. The HENlo host lists 3.65–3.74; use the maintained guide’s firmware selector to confirm the route for your exact version. Keep the Vita charged and connected to the internet.

• Choose your firmware and model
• Vita 1000 internal-memory-card procedure

HENlo host: https://jailbreak.psp2.dev/

Use http://jailbreak.psp2.dev in the Vita browser, as shown by the maintained guide. The HTTPS link above can be opened on a computer or phone.

1. Prepare the browserFollowing the video, allow cookies and enable JavaScript in the browser settings. Its preparation also clears cookies and search history before loading the host.
2. Enter the addressType the host into the Vita browser’s address bar. Check that the hostname is jailbreak.psp2.dev.
3. Start HENloChoose Unlock my Vita, then Unlock. Wait for the henlo-bootstrap menu to appear.
4. Install the homebrew componentsChoose Install henkaku, then Install VitaDeploy. When both complete, choose Exit.
5. Enable homebrew in SettingsOpen Settings > HENkaku Settings and enable Enable Unsafe Homebrew. Confirm VitaDeploy is now available in LiveArea.

• Maintained HENlo installation instructions
• Video · browser preparation and HENlo sequence

HENkaku enables homebrew in the current session. VitaDeploy is the installation toolbox. Ensō adds boot-time persistence; the next guide uses VitaDeploy’s documented firmware 3.65 preset.

Blaine Locklair · published 7 September 2026. The written guide follows the video’s English transcript and cross-checks the install details against Vita Hacks Guide. Open a chapter below to jump to the matching step.

• 0:00 · Preparation and setup
• 0:54 · Browser configuration
• 1:55 · Launching HENlo
• 3:24 · Installing HENkaku and VitaDeploy
• 4:00 · HENkaku settings
• 4:43 · Installing firmware 3.65 and Ensō
• 6:11 · iTLS installation
• 7:51 · Final configuration